Directory list and print pro v3.432/12/2023 Following the previous documentation we will go to the option Building the microcontroller using this configuration:.We can follow the official Klipper documentation to install it we also recommend using Kiauh, Fluidd Pi or MainsaiOS have images that greatly facilitate the installation process of all the necessary components.To use the USART connection we have to connect the UART-TX pin of our Raspberry with the USART-RX2 pin of our board, the UART-RX pin of our Raspberry with the USART-TX2 pin of our board. In the following example we can see how we have 16 microsteps for our X axis. Speaking of reliability is another important aspect when it comes to micro-steps, the stepper motors that our printers carry lose torque (and steps) at high revolutions so increasing this definition of steps will exponentially increase the reliability percentage and therefore that our pieces do not come out correctly. If you desire to read a great article about TMC Drivers not doubt in check this link: TMC Drivers: Discover the best drivers for 3D printing and their available technologies that the TMC drivers already perform the interpolation of these themselves to always offer maximum reliability and precision. With these micro-steps, the definition that we could achieve mechanically is practically impossible to achieve with normal printers. Micro-steps, although we can configure from 16 to 256 micro-steps, we do not advise you at all to use a value other than 16. #define ADVANCED_PAUSE_FEATURE // 3DWORK FILAMENT SENSORÄriver configuration, with our TMC2209 drivers in UART we have to correctly configure the advanced parameters that we will find in the HAS_TRINAMIC_CONFIG section.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |